Petkit Eversweet water heater

The smart heater is designed especially for the PETKIT Eversweet 2, which allows you to quickly warm up and keep warm water for your pet's in cold weather. The current water temperature is displayed on the LED screen on the top of the heater. The water can be heated up to 25 °C. 

How to install the heater in the water dispenser?

• Remove the water tank, filter unit and bowl from the water dispenser one by one
• Attach the heating components to the bottom of the heater using the suction cup
• Insert the heater into the water heater using the grooves
• Fasten the heater using Velcro 20mm above the bottom of the water to tighten, do the same with the top of the heater
• Pour water into the dispenser and insert the filter unit and bowl step by step
•  

If the LED screen displays a fault, the heater needs to be restarted to find the possible problem:

• E1 - Excessive supply voltage
• E2 - Low supply voltage
• E3 - Warmer current is too high
• E4 - Warmer current is too low
• E5 - No temperature sensor
• E6 - Temperature sensor is destroyed
• E7 - Water level sensor is damaged

Icons on the LED screen that do not require a restart:

• HH - Water temperature is higher than the device can detect   
• LL - Water temperature is lower than the device can detect 
• UU - Water shortage